Filter
Top Products
7 — ENG
D20249
1. Connect threaded end of quick connect wand to
spray gun as shown. Tighten securely.
ASSEMBLY
ASSEMBLY
2. Place assembled spray gun, quick connect, wand,
and chemical hose in gun/hose holder.
3. Add 30 weight engine oil (supplied) to engine.
Refer to engine manual supplied by engine manu-
facturer for procedure. Do not overfill. Use of a
funnel is recommended.
NOTE
There will be a slight amount of oil in the
engine from factory testing.
NOTE
The engine on this pressure washer is
equipped with a low oil sensor. The amount
of oil in the engine must be correct or the
engine will not start.
THE PUMP IS SHIPPED FROM THE FAC-
TORY WITH OIL IN IT AND A RED SHIP-
PING PLUG TO PREVENT ANY OIL FROM
LEAKING OUT OF THE PUMP DURING
SHIPMENT. ATTACHED TO THE SHIPPING
PLUG IS A PLASTIC BAG (SEE THE FOL-
LOWING PHOTO) WHICH CONTAINS THE
DIPSTICK/OIL PLUG THE SHIPPING PLUG
MUST BE REMOVED AND THE DIPSTICK/
OIL PLUG INSTALLED BEFORE THE PRES-
SURE WASHER IS OPERATED.
4. Using a 17 mm wrench, remove shipping plug
from pump by turning it counterclockwise. Dis-
card plug.
5. Remove dipstick/oil plug from plastic bag. Before
installing dipstick/oil plug into pump, check the
pump oil level. See Pump paragraph in Mainte-
nance section of this manual.
6. Remove five colored quick connect nozzles from
plastic bag and insert them into correct receptacle
on panel NOTE: Nozzles are color coded to
match colored squares on panel.