Filter
Top Products
13 — ENG
D20249
OPERATION
3. Move throttle control lever out of SLOW position,
about 1/3 of the way toward FAST position.
Throttle Control
Slow
Engine Switch
OFF
ON
5. Pull starter grip slowly until you feel resistance,
then pull briskly. Return starter grip gently.
Starter Grip
If engine does not start after two pulls, pull
the trigger on spray gun to relieve pressure
in hose. Failure to do so may cause dam-
age to starter recoil mechanism of engine
NEVER RUN ENGINE INDOORS OR IN EN-
CLOSED, POORLY VENTILATED AREAS.
ENGINE EXHAUST CONTAINS CARBON
MONOXIDE, AN ODORLESS AND DEADLY
GAS.
4. Turn engine switch to ON position.
6. If choke control lever is in CLOSED position, move
lever to OPEN position as engine warms up.
7. Move throttle control to FAST position.
WHEN USING THE HIGH PRESSURE
SETTING, DO NOT ALLOW THE HIGH
PRESSURE SPRAY TO COME IN CONTACT
WITH UNPROTECTED SKIN, EYES, OR
WITH ANY PETS OR ANIMALS. SERIOUS
INJURY CAN OCCUR.
DO NOT stop spraying water for more than
two minutes at a time. Pump operates in
bypass mode when spray gun trigger is not
pressed. If pump is left in bypass mode for
more than two minutes internal components
of the pump can be damaged.
DO NOT let hoses come in contact with
very hot engine muffler during or immedi-
ately after use of your pressure washer.
Damage to hoses from contact with hot
engine surfaces will NOT be covered by
warranty.
7. Depress trigger on gun to start water flow. Release
trigger to stop water flow.
STAND ON A STABLE SURFACE AND GRIP
GUN/WAND FIRMLY WITH BOTH HANDS.
EXPECT THE GUN TO KICK WHEN
TRIGGERED.
9. Adjust nozzle spray for the task being performed.
See Spray Nozzle instructions in the Operation
section.
Throttle Control
Fast
Fast
Slow