Filter
Top Products
12 — ENG
D20249
14. Add fresh, unleaded regular gasoline to engine
fuel tank.
TYPICAL HOOK-UP
Your pressure washer hookup should resemble this
diagram.
OPERATION
NEVER FILL FUEL TANK INDOORS. NEVER
FILL FUEL TANK WHEN ENGINE IS RUN-
NING OR HOT. DO NOT SMOKE WHEN FILL-
ING FUEL TANK.
NEVER FILL FUEL TANK COMPLETELY. FILL
TANK TO 1/2" BELOW BOTTOM OF FILLER
NECK TO PROVIDE SPACE FOR FUEL EX-
PANSION. WIPE ANY FUEL SPILLAGE FROM
ENGINE AND EQUIPMENT BEFORE START-
ING ENGINE.
NEVER RUN ENGINE INDOORS OR IN EN-
CLOSED, POORLY VENTILATED AREAS.
ENGINE EXHAUST CONTAINS CARBON
MONOXIDE, AN ODORLESS AND DEADLY
GAS.
PRE-START CHECKLIST
Once you reach this point, ensure you have completed
the following:
All safety instructions read and understood?
All hose connections are tightened and free of
any kinks, damage, or leaks?
Correct amount of engine oil and gasoline
added to engine?
Correct amount of oil in the pump?
Nozzle installed in end of wand?
Water supply (garden hose) turned on?
All operation instructions read and under-
stood?
If you can say "yes" to the items on the Pre-start
checklist, you are ready to start your pressure washer.
Garden
Hose
Chemical
Chemical
Hose
Hi-
Pressure
Hose
Pressure Washer
Wand
STARTING YOUR PRESSURE
WASHER
NOTE: Make sure water supply is turned on.
Never turn water supply off while pressure
washer engine is running or damage to
pump will result.
1. Move fuel valve lever to ON position.
2. Move choke control lever to CLOSED position.
NOTE
To restart a warm engine, move choke control
to ON position.
Fuel
Valve
Lever
ON
Choke Control
Lever
CLOSED
ON