Filter
Top Products
www.desatech.com
114144-01E
5
4.
Insert manifold into pole support (see Figure 2).
Insert the manifold assembly through the post by
passing through the hole in the post support. Note:
Make sure hose and regulator assembly attached
to manifold are never bent or kinked during instal
-
lation and operation of heater.
5. Attach pole to pole support (Figure 3). Place
pole into pole support center connector.
Tighten six set screws with hex allen wrench
supplied with heater. Note: Set screws are
threaded inside post support.
6. Put propane/LP cylinder cover on base assembly
(see Figure 4). Slide propane/LP cylinder cover
over pole and pole support. Be sure that the pro
-
pane/LP cylinder cover rests level on the base.
Figure 1 - Base Assembly
Legs
Base
Pole
Support
Ballast
Weight
Figure 2 - Installing Manifold Assembly
Pole
Support
Manifold
Assembly
Figure 3 - Pole to Pole Support
Pole
Support
Pole
Figure 4 - Propane/LP Cylinder Cover
Pole
Propane/LP
Cylinder
Cover
Base
ASSEMBLY INSTRUCTIONS
Continued