Filter
Top Products
www.desatech.com
114144-01E
4
26. Items or material, when stored under the
heater, will be subjected to radiant heat and
could be seriously damaged.
27. Use only in accordance with local codes, or in
the absence of local codes, with the National
Fuel Gas Code ANSI Z223.1
.
Any guard or other protective device
removed for servicing must be re
-
placed prior to operating the heater.
Surface temperatures become very
hot when operating heater. Children
and adults should stay away to avoid
burns or clothing ignition.
Young children should be carefully
supervised when they are in the area
of the heater.
Clothing or other flammable mate
-
rials should not be hung from the
heater, or placed on or near heater.
Installation and repair should be
done by a qualified service person.
The heater should be inspected
before use and at least annually by
a qualified service person. More
frequent cleanings may be required
as necessary. It is imperative that
control compartments, burners and
circulating air passageways of the
heater be kept clean.
CAUTION: The gas pressure
regulator provided with this ap
-
pliance must be used. This regu-
lator is set for an output pressure
of 11" W.C. (2.74 kPa).
SAFETY INFORMATION
Continued
PROPANE/LP SAFETY
WARNING: For outdoor use
only.
ASPHYXIATION HAZARD
• Do not use this heater for heating human
living quarters.
• Do not use in unventilated areas.
• The flow of combustion and ventilation
air must not be obstructed.
• Proper ventilation air must be provided
to support the combustion air require
-
ments of the heater being used.
• Refer to the Specifications, page 2, heater
data plate or contact DESA Heating Prod
-
ucts to determine combustion air ventila-
tion requirements of the heater.
• Lack of proper ventilation air will lead
to improper combustion.
• Improper combustion can lead to carbon
monoxide poisoning leading to serious
injury or death. Symptom of carbon mon
-
oxide poisoning can include headaches
dizziness and difficulty in breathing.
ASSEMBLY INSTRUCTIONS
Tools Required:
• #2 Phillips Head Screwdriver 1
• Adjustable Wrench 2
Inspect heater components for possible shipping
damage. If any is found, immediately notify the
dealer. Check to make sure that all components are
included with your heater (see pages 10 and 11).
POLE ASSEMBLY
1. Attach legs to base using two bolts, two lock
washers and two nuts (see Figure 1, page 5).
Insert bolts through legs and into top of base.
Attach lock washers and nuts from underneath
base. Finger tighten only. Repeat for each leg.
Do not fully tighten until next step.
2. Secure pole support to legs using two bolts, two
lock washers and two nuts. Repeat for each leg.
Wrench tighten nuts and bolts from step 1 and 2.
3. Attach ballast weight to base using one, long bolt,
lock washer and nut (see Figure 1, page 5).