Filter
Top Products
19
From just above the right axle carrier,
inside the right frame rail, slowly turn
the hex nylon lock nut at the end of
the brake rod as follows to adjust the
brake (Refer to Figure 18):
• Turn the nylon lock nut clockwise to
increase the braking force.
• Turn the nylon lock nut counter-
clockwise to decrease the braking
force.
Recheck the brake adjustment to
ensure proper operation, and readjust
as necessary. If brake adjustment
does not correct the problem, see your
authorized Cub Cadet dealer.
While guiding the transmission release
rod through keyhole and the oil fill
tube/dipstick into the transmission,
position the rear drawbar on the
frame. Secure with the four hex tapp
screws.
Turning Radius Adjustment
This tractor is equipped with hydraulic
power steering which is set at the
factory. The turning radius should be
equal for both left and right hand
turns. If adjustment is necessary
please contact your authorized Cub
Cadet dealer.
SECTION 9: MAINTENANCE
Maintenance Chart
‡ Change oil and filter after first 5 hours
† More often under dusty conditions
†† Clean every 25 hours or more often under dusty or dirty conditions
NOTE: We do not recommend the use of a pressure washer or garden hose to
clean your unit. They may cause damage to electrical components; spindles;
pulleys; bearings; or the engine. The use of water will result in shortened life
and reduce serviceability.
Operation to
be performed
Each Use
10 Hours
50 Hours
100 Hours
150 Hours
200 Hours
250 Hours
300 Hours
Grease front wheel bearings •
Grease L/R steering knuckles •
Grease front pivot axle •
Check engine oil level •
Change engine oil and filter ‡ •••
Check spark plug condition •••
Check transmission oil level •
Change transmission oil filter •••••
Change transmission oil ••
Check air cleaner & housing •
Clean & re-oil foam air
pre-cleaner
††
Change air cleaner
paper cartride
†††