Filter
Top Products
19se c t i O n 5 — Op e r a t i O n
Examine the belts for cuts, fraying, and excessive c.
wear. Replace if any of these are detected.
Replace the deck cover.d.
Check if deck is level. When correctly adjusted the mower
deck should be level side to side, and the front of the deck
should be approximately ⁄
If deck needs to be leveled, refer to the Maintenance &
Adjustments section.
Lubricate all pivot points listed in the Maintenance &
Adjustments section.
and for maintaining complete control of the tractor. Refer
adjusting the seat.
Safety Interlock System
This tractor is equipped with a safety interlock system for the
protection of the operator. If the interlock system should ever
malfunction, do not operate the tractor. Contact your authorized
Cub Cadet Dealer.
The safety interlock system prevents the engine from
cranking or starting unless the speed control pedals are in
the neutral position, the parking brake is engaged, and the
To avoid sudden movement when disengaging the parking
brake, the safety interlock system will shut off the engine
if the speed control pedals are moved to a position other
than the neutral position when the parking brake is
engaged.
The safety interlock system will shut off the engine if the
operator leaves the seat before engaging the parking
brake.
The safety interlock system will shut off the engine if the
of whether the parking brake is engaged.
NOTE:
position to restart the engine.
Starting the Engine
WARNING! This tractor is equipped with a safety
interlock system designed for the protection of the
operator. Do not operate the tractor if any part of
check the functions of the interlock system for
proper operation.
WARNING! For personal safety, the operator must
be sitting in the tractor seat when starting the
engine.
2.
control pedals in the neutral/start position.
Engage the parking brake.
4.
position.
5.
temperatures).
6.
and release it as soon as the engine starts; however, do not
at a time. If the engine does not start within this time, turn
Cold Weather Starting
When starting the engine at temperatures near or below
freezing, ensure the correct viscosity motor oil is used in the
follows:
has much more starting capacity than a cold battery.
NOTE:
for shut-off valve to function correctly. This also provides
desired engine cranking speed.
2.
Crank engine for about 5 seconds and stop.
4.
starts running.
Repeat if necessary.5.
Using Jumper Cables To Start Engine
WARNING!
produce explosive gasses. Make certain the area is
well ventilated, wear gloves and eye protection, and
avoid sparks or flames near the battery.
If the battery charge is not sufficient to crank the engine,
recharge the battery. If a battery charger is unavailable and
the tractor must be started, the aid of a booster battery will be
necessary. Connect the booster battery as follows:
Connect the end of one cable to the disabled tractor
Connect one end of the other cable to the booster 2.
that cable to the frame of the disabled tractor, as far from
the battery as possible.
instructions previously provided; then disconnect
the jumper cables in the exact reverse order of their
connection.
4.
as soon as possible to eliminate the need for jump starting.