Filter
Top Products
Section 7— Service28
Remove the two idler pulleys by removing the hex screws
and flange lock nuts that secure them to the deck and the
idler arm. See Figure 7-8. Do not lose any of the hardware
when removing the hex screw and flange lock nut.
Hex Screw
Hex Screw
Pulley Cap Pulley Cap
Washer
Belt Guard
Belt Guard
Washer
Idler Arm
Flange Lock Nut
Flange Lock Nut
Idler Pulleys
Figure 7-8
NOTE: Take note of the position of the belt guards to
ensure they are properly re-installed.
4. Remove the belt from the spindle pulleys.
5. Install the new belt around the spindle pulleys as shown
and reinstall the belt covers. See Figure 7-7.
6.
hardware and tighten the flange lock nut to secure the
assembly. See Figure 7-8.
7. Route the belt as shown in Figure 7-7 and then reinstall the
deck.
46” Deck
Remove the deck from beneath the tractor, (refer to Deck
Removal on page 26).
2. Remove the hex washer screws securing the belt covers to
PTO Pulley
Idler Pulley
Idler Pulley
Belt Cover
Hex Washer
Screws
Belt Guard
Spindle Pulley
Spindle Pulley
Idler Arm
Figure 7-9
Remove the two idler pulleys by removing the hex screws
and flange lock nuts that secure them to the deck and the
when removing the hex screw and flange lock nut.
Pulley Cap
Washer
Flange Lock Nut
Flange Lock Nut
Pulley Cap
Idler Pulley
Idler Pulley
Belt Guard
Spacer
Shoulder Spacer
Idler Arm
Hex Screw
Flat Washer
Hex Screw
Figure 7-10
NOTE: Take note of the position of the belt guard to ensure
they are properly re-installed.
4. Remove the belt from the spindle pulleys.
5. Install the new belt around the spindle pulleys as shown