Filter
Top Products
Section 5 — operation 17
Starting the Engine
WARNING! This tractor is equipped with a safety
interlock system designed for the protection of the
operator. Do not operate the tractor if any part of the
system is malfunctioning. Periodically check the
function of the interlock system for proper operation.
WARNING! For personal safety, the operator must
be sitting in the tractor seat when starting the
engine.
NOTE:
instructions and refer to the Assembly & Set-Up section for
gasoline fill-up instructions.
2. Engage the parking brake by pressing forward on the brake
pedal , then press down on the parking break/cruise
control lever and then release the brake pedal . Refer to
Brake Pedal
Parking Brake/Cruise Control Lever
Figure 5-1
4. position.
NOTE: If the engine is warmed up, it may not be necessary to
position.
5. Turn the ignition key clockwise to the START position.
After the engine starts, release the key. It will return to the
run position.
CAUTION:
position for longer than ten seconds at a time. Doing
starter.
6. As the engine warms up, gradually pull the throttle/choke
control lever rearward past the choke detent position.
NOTE:
position while operating the tractor. Doing so will result
7. Allow the engine to run for a few minutes at mid throttle
before putting the engine under load.
8.
indicator light or oil pressure light come on, immediately
stop the engine. Have the tractor inspected by your Cub
Cadet dealer.
Cold Weather Starting
When starting the engine at temperatures near or below freezing,
ensure the correct viscosity motor oil is used in the engine and the
battery is fully charged. Start the engine as follows:
has much more starting capacity than a cold battery.
2. Use fresh winter grade fuel. Winter grade gasoline has
higher volatility to improve starting. Do not use gasoline
left over from summer.
Follow the previous instruction for Starting the Engine.
Using Jumper Cables To Start Engine
WARNING!
produce explosive gasses. Make certain the area is
well ventilated, wear gloves and eye protection, and
avoid sparks or flames near the battery.
If the battery charge is not sufficient to crank the engine,
recharge the battery. If a battery charger is unavailable and
the tractor must be started, the aid of a booster battery will be
necessary. Connect the booster battery as follows:
Connect the end of one cable to the disabled tractor
2. Connect one end of the other cable to the booster
that cable to the frame of the disabled tractor, as far from
the battery as possible.
Start the disabled tractor following the normal starting
instructions previously provided; then disconnect the
jumper cables in the exact reverse order of their connection.
4.
as soon as possible to eliminate the need for jump starting.
Stopping the Engine
2. Engage the parking brake.
position
and allow the engine to idle for about one minute.
4. position and remove
the key from the ignition switch.
NOTE: Always remove the key from the ignition switch to prevent
accidental starting or battery discharge if the equipment is left
unattended.