Cub Cadet RZT-S Lawn Mower User Manual


 
15Section 4 — controlS & FeatureS
Parking Brake/
Cruise Control Lock Pedal
The parking brake/cruise control lock pedal is
located at the base of the steering column. It
is used to engage the parking brake when the
tractor is at rest. Engaging the lever while the
tractor is in motion allows the tractor to remain
at a constant ground speed without applying
pressure to the forward drive pedal. Refer to

regarding the parking brake as well as the cruise control feature.
NOTE: 
fastest ground speed. If the operator should attempt to do so,
the tractor will automatically decelerate to the fastest optimal
mowing ground speed
NOTE: The parking brake must be set if the operator leaves the
seat with the engine running or the engine will automatically
shut off.
WARNING! Never leave a running machine

brake, stop engine and remove key to prevent
unintended starting.
Forward Drive Pedal
The forward drive pedal is located on the right side
of the tractor, along the running board. Press the
forward drive pedal forward to cause the tractor to
travel forward. Ground speed is also controlled with
the forward drive pedal. The further forward the
pedal is pivoted, the faster the tractor will travel. The

pressed.
Reverse Pedal
The reverse drive pedal is located on the right side of
the tractor along the running board. Ground speed
is also controlled with the reverse drive pedal. The
further downward the pedal is pivoted, the faster the
tractor will travel. The pedal will return to its original

Transmission Bypass Valves
The transmission bypass valves (one for each the RH and LH
transmission) are located under the tractor on the back of each
transmission inside the rear wheels.
When engaged, the two valves open a bypass within the
hydrostatic transmissions, which allows the tractor to be pushed
short distances by hand. Refer to the Assembly & Set-Up section
for instructions on using the bypass feature.
PARK BRAKE/
CRUISE CTRL.
LOCK PEDAL
I23746
Cup Holder
The cup holder is located on the RH console to the right of the

Storage Tray
The storage tray is located at the rear of the RH console.
Seat Adjustment Lever
The seat adjustment lever is located below the left side of the
seat. The lever allows for adjustment of the fore to aft position of

instructions on adjusting the seat position.