LUBRICATION GUIDE
(International Cub Cadet 123 Tractor)
--After Every 10 Hours of Operotion
1. Oil filler cap and bayonet-type
oj I level gauge.
Check the oil (with the engine stopped) and add sufficient
new oil to bring it to the "FULL" mark on the gauge. Do
not overfill. Do not operate the engine if the oil level is
below the "LOW" mark on the gauge.
Use IH-251 HEP grease or equivalent #2 multi-purpose
lithium grease and apply sufficient grease to flush out oldgrease
and dirt.
2.
Steering knuckles (2).
3. Front axle pivot pin.
4. Transmission oil filter,
Note: After the first 10 hours only, remove the old filter
and replace with a new filter as instructed on poge 27.
Change the oil filter after 50 hours and every 100 hours
of operation thereafter.
--After Every 30 Hours of Operation
While the oil is warm, remove the drain plug (5) and
drain all of the oil from the crankcase. RepLace the drain
plug. Remove the crankcase oil filler cap (I). Refill the
crankcase with new oil up to the "FULL" mark on the oil
level gauge. Refer to the "Lubrication Table" for the
proper quantity and viscosity to use.
5.
Engine crankcase.
--After Every 50 Hours of Operotion
Note: After the first 50 hours only. remove the old filter
and replace with a new filter as instructed on page 21.
Change the oil filter every 100 hours of operation
thereafter.
6. Transmission oil filter.
--After Every 100 Hours of Operation
Transmissian ail filter.
Change the oil filter and replace with a new filter as
instructed on poge 27.
--Periodic
Transmission
Check the oil level periodically or once a year. Keep the
lubricant up to the level plug (8) on the rear of the trans-
mission case cover.
8.
Oi I level and fi Iler plug.
31