Cub Cadet 5234D Lawn Mower User Manual


 
13
X. Instrument Panel
Figure 11
1. Fuel Gauge
The fuel gauge monitors the fuel level in the fuel
tank. The needle pointing to the right indicates a full
tank. The ignition switch must be in the ON position
to activate the fuel gauge.
2. Tachometer
The tachometer shows the engine speed in revolu-
tions per minute (RPM). Optimal engine operating
speed is approximately 3000-3500 RPM. When
operating PTO driven attachments the RPM indica-
tor needle should be within the green range on the
tachometer dial.
3. Battery Indicator Light
Bulb illuminates and battery voltage is displayed
briefly when the ignition switch it turned to the
"ON" position.
Illuminates to indicate the battery voltage has
dropped below 11.5 (+0.5/-1.0) DC volts. The
battery voltage is also displayed on the hour
meter. If this indicator and display come on
during operation, check the battery and charging
system for possible causes and/or contact your
Cub Cadet dealer.
4. Oil Pressure Indicator
This warning lamp indicates low engine oil pressure.
If this indicator illuminates, stop the tractor
immediately and check the engine oil level. If the oil
level is within the operating range, but the light
remains on, contact your Cub Cadet dealer. NOTE:
The oil pressure indicator may illuminate when the
key switch is turned to the on position, but should
turn off when the engine is started.
5. PTO Engaged Indicator
This indicator illuminates whenever the PTO switch
is pulled upward in the "ENGAGED" position while
the key switch is turned to the "ON" position. Check
this indicator if the engine will not crank with the key
switch in the "START" position—the indicator should
not be illuminated. If necessary, move the PTO
switch to the "DISENGAGED" position.
6. Brake Engaged Indicator
This indicator illuminates whenever the brake pedal
is fully depressed or the parking brake is engaged
and the key switch is turned to the "ON" position.
Check this indicator if the engine will not crank when
the key switch is turned to the "START" position—
the indicator should be illuminated. If necessary,
fully depress the brake pedal.
7. Hour Meter/Battery Display
The hour meter records the hours and tenths of an
hour (right most digit) that the tractor has been
operated.
The hour meter is activated when the key switch
is turned to the “ON” switch position. Because
the key switch may be accidentally left in the
"ON" position, a record of the actual hours of
operation should be kept to assure mainte-
nance procedures are completed according to
the schedule in this manual.
When the key switch is turned to the "ON"
position, the battery indicator light briefly
illuminates and the battery voltage is briefly
displayed. The display then changes to the
accumulated hours.
8. Engine Coolant Temperature Light
Illumination of this warning lamp indicates the engine
coolant temperature has risen above the prescribed
operating range. If the light comes on while operat-
ing the tractor, eliminate all loads and try cooling the
engine by running at mid throttle for a few minutes.
Stop the engine and allow to cool; then check for
possible causes (e.g. low coolant level, plugged radi-
ator screen).
9. Glow Plug Indicator Light
Illuminates when the ignition switch is turned to the
ON position. The light remains lit for a preset time
while the glow plugs heat the precombustion
chambers of the diesel engine.
RPM
x1000
04
FUEL
EF
HOURS 1/10
1
2
4
5
6
3
Green
Range
7
8
9