Filter
Top Products
International Cub Cadet 86, 108 and 128 Tractors
1. Shifter lever
OPERATING THE REAR POWER TAKE-OFF
WITH THE TRACTOR STANDING STILL
1. Move the throttle lever back to the "SLOW"
speed.
2. Depress the pedal and move the transmission
gearshift lever to the neutral position.
1. Power take-off guard
2. Grease fitting
3.
Move the shifter lever forward to the engaged
position.
If your tractor is equipped with a rear power
take-off, the following instructions should be
carefully studied and followed.
4. Move the throttle lever forward to the "FAST"
position and slowly release the pedal.
The rear power take-off is started and stopped by
the same engine clutch as the tractor. Be sure to
disengage the engine clutch before moving the
power take-off shifter lever.
OPERATING THE REAR POWER TAKE-OFF
WITH TRACTOR IN MOTION
Follow steps 1 thru 3 outlined above. Keep the
pedal depressed, move the transmission gearshift
lever to the speed desired and advance the throttle
lever. Slowly release the clutch pedal. This will
start the tractor in motion with the power take-off
in operation.
A CAUTION! The shifter lever should always
be in the disengaged (rearward) position
when the power take-off is not in use.
Always cover the power take-off exposed shaft
with the guard when the power take-off is not
being used.
17