Filter
Top Products
ASSEMBLY
REMOTE CHUTE CONTROL KNOB
1. Thread the 3/8-16" hex jam nut onto the lever until the
nut reaches the end of the thread. (See Figure 12)
2. Thread the plastic knob as far as possible and ensure
that the knob points forward.
3. Tighten the 3/8-16" hex jam nut against the knob
securely.
4. Remove cable ties from chute cable and read and re-
move hang tags.
The headlight on your snow blower is positioned down
for packaging purposes. Rotate upward for operating
position.
Figure 12
NOTE: This snow blower was shipped WITH OIL in the engine. See "Before Starting Engine" in-
structions in the Operation section of this manual before starting engine.
F-001008J 11
NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS
NEED PARTS? VISIT HTTP://WWW.MANUALBUDDY.COM/PARTS/