Craftsman 919.67937 Portable Generator User Manual


 
KNOW YOUR GENERATOR
Read this Owner's IVianual and Safety Rules be_
fore operation of your Generator, Compare this
illustration with your generator to familiarize yourself
with the location of various controls and adjustments.
Save the manual for future references.
FUEL TANK= Capacity of 4 US gallons.
CHOKE SWITCH= Lever used to start cold engine.
ENGINE RUN/STOP SWITCH= Sets engine in starting
mode for recoil starter - Stops running engine.
ENGINE OiL FILL- Place where engine oil is poured.
CiRCUiT BREAKER= Each receptacle has a circuit
breaker to protect the generator from overloading.
120 VOLT DUPLEX RECEPTACLES- Used to supply 1800
watts of electrical power per receptacle for operations.
Protected by 15 amp circuit breaker.
120/240 VOLT TWISTLOCK RECEPTACLE- Used to
supply 1800 watts of electrical power for 120 volt operations
and for 240 volt operation 3750. Wiil only supply 1875 watts
each if both receptacles are being used. Protected by 15
amp circuit breaker.
120 VOLT TWISTLOCK RECEPTACLE- Used to supply
1800 watts of power per receptacle protected by a 15 amp
circuit breaker_
AIF(CLFJ_HER-(nciudes filter element and foam pre-cieaner
that limits the amount of dirt that enters the engine.
FULL POWER SWITCH - Switch used to convert every
receptacle on the panel, when placed in the 120 position,
to a 120 volt receptacle. This wiil allow you to receive the
fuil capacity of the generator by using ail 120 volt recep-
tacles. When in the 120/240 position, you wiil only be able
to use half of the 3750 watts when using the 120 volt recep-
tacles. But in this position, the fuil 3750 watts can be re-
ceived in the 240 twistiock receptacle.
IDLE COHTROL SWITCH- When on, allows the engine to
run at a lower speed when there is no load on the generator.
AiR CLEANI=R
(DLE CONTROL
SW(TCH
FULL
POWER
SWITCH
t 20/240
TWJSTLOCK
RECEPTACLE
t 20 TW|STLOCK
RECEPTACLE
9 -- ENG