Filter
Top Products
Cennectin9 Electrical Loads
Let engine run and warm up for about five minutes
Piug in the desired 120 or 240 voits toob.
DO NOT connect 240 volt equipment to the 120 volt
duplex receptacles.
DO NOT connect 3-phase loads to the panel
receptacles.
iMPORTANT; You should always add up the rated
watts of all lights, tools and appliances you are power-
ing at one time. This total should not exceed the rated
capacity of your generator or circuit breaker rating of
the receptacle supplying power.
Steppin9 The Engine
Disconnect all electrical loads.
Switch the start/off switch to the off position.
iMPORTANT: Never store engine with fuel in tank,
indoors, or in enclosed, poorly ventilated areas or where
fuel fumes may reach an open flame.
CUSTOMER RESPONSBBBLBTBES TABLE
MAINTNENANCE TASK
Before each
use
Every 25
Hours of Every
Season
Every 50
Hours of Every
Season
Check oil leve! X See Note 2
Change oil X See Note 1
Clean Air Filter Assembly X
Check Spark Plug X
Prepare Unit for Storage
Every i00
Hours of Every
Season
x
Prepare unit for storage if it is to remain idmefor more than 30 days,
Note 1: Change oil after first two (2) operating hours and every 50 operating hours thereafter, more often if operated in
extreme dusty or dirty conditions.
Note 2: Check oil after 5 hours of operation (See page 14 - ENGINE MAINTENANCE - Changing Engine Oil.)
13 -- ENG