Filter
Top Products
LY / E-OPERATION
iNSTALL TRACTION DRIVE CONTROL ROD
(See Figs. 3 and 4)
The traction drive control rod has the long loop on the end
of the spring as shown.
1. Slide rubber sleeve up rod and hook end of spring into
pivot bracket with loop opening down as shown.
2. With top end of rod positioned under left side of control
panel, push rod down and inserttop end of rod intohole
in drive control bracket. Secure with retainer spring.
iNSTALL AUGER CONTROL ROD (See Figs. 5 and 6)
The auger control rod has the short loop on the end of the
spring as shown.
1. Slide rubber sleeve up rod and hook end of spring into
control arm with loop opening up as shown.
2. With top end of rod positioned under right side of
control panel, push down on rod and insert end of rod
into hole inauger control bracket. Secure with retainer
spring.
BRACKET
DRIVE
CONTROL
ARM
AUGER
CONTROL
ROD
RUBBER
SLEEVE
FIG. 3
DRIVE RETAINER
SPRING
CONTROL
BRACKET
FIG. 4
FiG, 5
AUGER CONTROL ROD
RETAINER
SPRING
AUGER
CONTROL
LEVER
CONTROL
BRACKET
FIG. 6