Filter
Top Products
GASOLINE
CONTROL
OPERATION
ELECTRIC AUGER
START BUTTON CONTROL
LEVER DRIVE SPEED
RECOIL _ONTROL LEVER
STARTER
HANDLE
CHUTE
DEFLECTOR
DISCHARGE CHUTE CONTROL LEVER
DEFLECTOR REMOTE
CONTROLLEVER
DRIVE
CONTROL
LEVER
SAFETY
iGNiTiON
KEY
ON / OFF
SWITCH
NOTE: iTEMS ABOVE
ARE SHOWN iN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT,
\
CHUTE
CLEAN=OUT TOOL
=H TURN
TRIGGER
LIGHT
KNOB
TOOLBOX
O DRIFT CUTTER
AUGERS
PLATE
FIG. 10
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox = used to store spare shear bolts, locknuts and
wrench.
Safety ignition key - must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button = used for starting the engine.
Recoil (auxiliary) starter handle- used forstarting engine.
Primer = pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control = used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
LH and RH turn triggers - used to steer the snow thrower.
10
Drive speed control lever = used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever = used to engage power-pro-
pelled forward or reverse motion of snow thrower.
Auger control lever = used to engage auger motion
(throw snow).
Discharge chute control lever = used to change the
direction the snow is thrown.
Deflector remote control lever = used to change the
distance the snow is thrown.
Skid plate = used to adjust height of scraper bar from ground.
Drift cutter - used to cut through deep snowdrifts.