Filter
Top Products
ASSEMBLY
:: ii_Ul, i ill ,l_ i i..... i,
CONNECT SHIFT ROD (See Fig. 6)
, Insert end of shift rod farthest from bend into hole of
shift lever indicator.
, Insert hairpin clip through hole of shift rod to secure.
• Insert other end of shift rod into hole in shift lever,
• Insert second hairpin clip through hole of shift rod,
REMOVE TILLER FROM CRATE
, Make sure shift lever indicator is in "N" (neutral) posi-
tion (See Fig. 6)
• Tilt tillerforward byliftinghandle, Separate cardboard
cover from leveling shield.
• Rotate tiller handle to the right and pull tiller out of
carton,
ATTACH THIS END
TO SHIFT LEVER
INDICATOR
ATTACH THIS
END TO SHIFT
LEVER _.\
-\,
SHIFT ROD
HAIRPIN SHIFT
CLIP LEVER
INDICATOR
SHIFT
HAIRPIN CLiP
SHIFT ROD
INSERT CABLE CLIP (See Fig. 7)
• Insert plastic cable clipinto hole on the back of handle
column, Push cables into clip.
CABLES
'CABLE CUP
FIG. 7
CHECK TIRE PRESSURE
The tires on your unit were overinflated at the factory for
shipping purposes. Correct and equal tire pressure is
important for best tilling performance.
° Reduce tire pressure to 20 PSI,
HANDLE HEIGHT
° Handle height may be adjusted to better suit operator.
(See "TO ADJUST HANDLE HEIGHT' in the Service
and Adjustments section of this manual),
FIG. 6
8