Filter
Top Products
OPERATION
i llllllll,i i,Hlllll , ,,i,,,lll,ll i i ,,,lll,,_
CULTIVATING
Cultivating is destroying the weeds between rows to pre-
vent them from robbing nourishment and moisture from the
plants. At the same time, breaking up the upper layer of soil
crust will help retain moisture in the soil, Best digging depth
is 1" to 3" (2°5-7°5 cm), Lower the outer side shields to
protect small plants from being buried.
• Cultivate up and down the rows at a speed which will
allow tines to uproot weeds and leave the ground in
rough condition, promoting no further growth of weeds
and grass (See Fig,.15).
©
\f
A
t--..
©
\J
A
FIG. 15
ADJUST WHEELS FOR CULTIVATING (See
Figs. 16 and 17)
• Place blocks under righthand side of tillerand remove
hairpin clip and clevis pin from right hand wheel,
• Move wheel outward approximately 1 inch (2.5 cm)
until hole in inner wheel hub lines up with inner hole in
axle_
OUTER VIEW OF TIRE
CLEVIS
PIN
HAfRPIN
CUP
FIG. 16
• Replace clevis pin and hairpin clip on inside of wheel
and remove blocks.
o Repeat preceding steps on left hand side.
NOTE: In extremely rough conditions and while cultivating,
the wheels should be moved outward on the axle for
increased stability.
INNER VIEW OF TIRE
CLEVIS k\\
PIN
HAIRPIN
CLIP
FIG. 17
13