Filter
Top Products
ASSEMBLY
......... ................................................. i i ,, illl ii ll,,
Your' new tiller has been assembled atthe factory with exception of those parts left unassembled for' shipping purposes, To
ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary' to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set willmake assembly easier_ Standard
wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(t) Screwdriver
(t) Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
FRONT
LEFT RIGHT
OPERATOR'S
POSITION
FIG. 1
CONTENTS OF HARDWARE PACK
.................. ........ i illllllllll ijiiii ii ii Hll : ....
!tIIIHI/Y
(2) Handle Locks (2) Carriage Bolts 3/8-16 UNC x 1 Gr. 5 (2) Center Locknuts 3/8-16 UNC
........... •:::: ......................................................................................................
(1) Rat Washer 13/32 x 1 x 11 Ga. (1) Handle Lock Lever
(2) Hairpin Clips
(1) Cable Clip
(1) Owner's Manual
6