Filter
Top Products
INSERT CABLE CLIP
• Insert plastic cable clip into hole on the
back of handle column. Push cables
into clip.
Handle Column
Cables
Attach this end to shiftlever -..-......_._..._
_-.-Attach this End To shift _ Shift Rod
Lever Indicator
Shift Lever
• Hairpin ;lip Indicator
Shift ROd
Cable Clip
CONNECT SHIFT ROD
• Insert end of shift rod farthest from bend
into hole of shift lever indicator.
• Insert hairpin clip through hole of shift
rod to secure.
• Insert other end of shift rod into hole in
shift lever.
• Insert second hairpin clip through hole of
shift rod with bend of clip on right side.
REMOVE TILLER FROM CRATE
• Adjust handle assemby to lowest posi-
tion. Be sure lock lever is tightened
securely.
• Make sure shift lever indicator is in "N"
(neutral) position.
• Tilt tiller forward by lifting handle.
Separate cardboard cover from leveling
shield.
• Rotate tiller handle to the right and pull
tiller out of carton.
CHECK TIRE PRESSURE
The tires on your unit were overinflated at
the factory for shipping purposes. Correct
and equal tire pressure is important for
best tilling performance.
• Reduce tire pressure to 20 PSI.
HANDLE HEIGHT
• Handle height may be adjusted to better
suit operator. (See "TO ADJUST HAN-
DLE HEIGHT" in the Service and
Adjustments section of this manual).
7