Filter
Top Products
ENGINE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
• The throttle control has been preset at
the factory and adjustment should not
be necessary. If adjustment is neces-
sary, proceed as follows:
• With engine not running, move remote
throttle control lever to "FAST" position.
• If throttle lever on engine touches high
speed stop, no further adjustment is
necessary. If throttle lever does not
touch high speed stop, continue with
adjustment procedure.
• Loosen cable clamp screw.
• Move throttle lever up until it touches
high speed stop, and hold in this posi-
tion.
• Tighten cable clamp screw securely.
Fuel Tank / Clamp
,Screw
and Wire
TO ADJUST CARBURETOR
The carburetor has been preset at the fac-
tory and adjustment should not be neces-
sary. However, engine performance can
be affected by differences in fuel, tempera.
ture, altitude or load, If the carburetor
does need adjustment, contact your near-
est authorized service center/department
IMPORTANT: Never tamper with the
engine govemor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed set-
ting can be dangerous. If you think the
engine-governed high speed needs adjust-
ing, contact your nearest authorized ser-
vice centerldepartment, which has the
proper equipment and experience to make
any necessary adjustments.
Control
Lever
18