Filter
Top Products
The cutting height range is approximately
1-1/2" to 4". The heights are measured
from the ground to the blade tip with the
engine not running. These heights are
approximate and may vary depending
upon soil conditions, height of grass and
types of grass being mowed.
* The average lawn should be cut to
approximately 2-1/2 inches during the
cool season and to over 3 inches
during hot months. For healthier and
better looking lawns, mow often and
after moderate growth.
= For best cutting performance, grass
over 6 inches in height should be
mowed twice. Make the first cut
relatively high; the second to desired
height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted
when they are slightly off the ground
when mower is at the desired cutting
height in operating position. Gauge
wheels then keep the deck in proper
position to help prevent scalping in most
terrain conditions.
NOTE: Adjust gauge wheels with tractor
on a flat level surface.
1. Adjust mower to desired cutting
height.
2. Lower mower with lift control. Re-
move rear retainer spring and clevis
pin which secure each gauge wheel.
3. Lower gauge wheels to ground.
Raise gauge wheels slightly to align
holes in bracket and gauge wheel bar
and insert clevis pins. Gauge wheels
should be slightly off the ground.
4. Replace retainer springs into clevis
pins.
Retainer Clevis Pin
Gauge
Wheel
Bar
Gaug_ __
Wheel
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt by
the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine.
1. Select desired height of cut.
2. Lower mower with attachment lift
control.
3. Start mower blades by engaging
attachment clutch control.
TO STOP MOWER BLADES -
disengage attachment clutch control.
_CAUTION: Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector
shield in place.
Attachment Clutch Attachemnt Lift
Switch Pull Out to Lever High
"Engage" Position
,C'
Low
":" Position
to
"Disengage"
Deflector
Shield
TO OPERATE ON HILLS
_CAUTION: Do not drive up or down
hills with slopes greater than 15° and do
not drive across any slope.
* Choose the slowest speed before
starting up or down hills.
, Avoid stopping or changing speed on
hills.
= If slowing is necessary, move throttle
control lever to slower position.
, If stopping is absolutely necessary,
push clutch/brake pedal quickly to
brake position and engage parking
brake.
= Move motion control lever to slowest
setting.
IMPORTRANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is de-
pressed.
° To restart movement, slowly release
parking brake and clutch/brake pedal.
* Slowly move motin control lever to
slowest setting.
, Make all turns slowly.
16