Filter
Top Products
Door
INSTALL SEAT
Adjust seat before tighteningadjustment
knob,
1. Remove adjustment knob end fiat
washer secudng seat to cardboard
packing and set aside for assembly of
seat to tractor.
2. Pivot seat upward and remove from
the cardboard packing, Remove the
cardboard packing and discard,
3. Place seat on seat pan so head of
shoulder bolt is positionedover large
slotted hole in pan.
4. Push down on seat to engage
shoulder bolt in slot and pullseat
towardsroar of tractor.
5. Pivot seat and pan forward end
assemble adjustment knob and fiat
washer loosely. Do not tighten.
6. Lower seat into operating position and
sit inseat,
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal ell the way down.
8. Get off seat withoutmovingits
adjusted position.
9. Raise seat and tighten adjustment
knob securely,
Seat
Bolt
Flat Washer
NOTE: You may now rollor driveyour
tractor offthe skid. Follow the appropriate
instructionbelow to remove the tractor
from the skid.
TO ROLLTRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plungerand raise
attachment liftlever to its highest
position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place gearshift lever in neutral {N)
position,
4. Roll tractorforward off skid.
5. Remove banding holding deflector
shield up against tractor.
TO DRIVETRACTOR OFF SKID (See
Operation section for location and
function of controls)
,_WARNING: Beforestarting, read,
understand and follow all instructionsin
the Operation section of this manual. Be
sure tractoris in a well-ventilated area.
Be sure the area in front oftractor isclear
of other people and objects.
1. Be sure all the above assembly steps
have been completed,
2. Check engine oillevel and fillfuel
tank with gasoline.
3. Sit on seat in operating position,
depress elutch/brake pedal and set
the parking brake.
4. Place gear shiftlever in neulfal (N)
position.
5, Press lift lever plungerand raise
attachment liftlever to itshighest
position.
6. Startthe engine. After engine has
started, move throttle controlto idle
position.
7. Depress clutch/broke pedal intofull
"BRAKE" position and hold. Move
gearshift lever to 1stgear.
8. Slowly release clutch/brake pedal and
slowlydrive tractoroff skid.
9. Applybrake tostop tractor, set parking
brake and place gearshift lever in
neutral position.
10.Turn ignitionkey to "OFF" position.
Continue with the instructionsthat follow.
9