Filter
Top Products
Yournew tractor has been assemb|ed at the factory with exceptionof those partslel
unassembled for shipping purposes, To ensure safe and proper operation of your
tractor all parts and hardware you assemble must he tightened securely.Use the
correct toolsas necessary to insure proper tightness. Review the video cassette be
you begin,
TOOLS REQUIRED FOR
ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below.
(1) 9/16"wrench (1) Pliers
(2) 1/2"wrench (1) Utility knife
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means, from your pointof
view, when you are in the operating
position (seated behind the steedng
wheel),
TO REMOVETRACTOR FROM
CARTON
UNPACK CARTON
1. Remove all accessible loose parts
and partscartons from carton.
2. Cut. from top to bottom, alonglines on
all four corners of carton, and lay
panels flat.
3. Check for any additional loose parts
or cartons and remove.
BEFORE REMOVINGTRACTOR
FROM SKID
ATTACHSTEERINGWHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
1. Slide extension shaft onto lower
steering shaft. Align mounting holes
in extension and lower shafts and
install 5/16 bex bolt and _ocknut.
Tighten securely.
2. Place tabs of steering boot over tab
slotsin dash and push down to
secure.
INSTALL STEERING WHEEL
3, Positionfront wheels of the tractor so
they are pointing straight forward.
4. Remove steedng wheel adapter from
steering wheel and slide adapter onto
steering shaft extension.
5. Positionsteering wheel so cross bars
are horizontal (left to right) and slide
inside boot and onto adapter.
6. Assemble large flat washer, 3/8 Ioc
washer, 3/8 hex bolt and lighten
securely.
7. Snap steering wheel insert into cel
of steedng wheel.
8. Remove protective matedals from
tractor hood and gdll.
IMPORTANT: Check for and remove
staples in skid that may puncturetires
where tractor isto rolloff skid.
HOWTO SET UPYOURTRACTOR
CHECK BATTERY
1. Lift seat panto raisedposition end
open batteryboxdoor.
NOTE: If this batteryisputintoservice
after month and year indicatedon lab,
(label located between terminals) cha
batteryfor minimum ofone hour at 6-1
amps. (See "BATTERY" in Maintenanc(
section of this manual for charging
instructions).