Filter
Top Products
ASSEMBLY INSTRUCTIONS FOR
USING YOUR UNIT AS A VACUUM
NOTE: Assembly instructionsfor using
your unit as a blower is explained in
the previous section.
4_kWARNING: Stop the unit and dis-
connect from the power source before
opening the inlet cover or attempting to
insert or remove the inlet restriotoror
vacuum tubes, The motor must be
stopped and the impeller blades no
longer turning to avoid serious injury
from the rotating blades.
NOTE: If you have already assembled
your unit for use as a blower, remove
the blower tube and nozzle.
REMOVE THE INLET RESTRICTOR
An inletrestrictoris used when using
your unitas a blower, This restitctoris
not used dudng vacuum use, and must
be removed dudng essembly for vacu-
um use,
NOTE: Be sure to keep the inlet re-
strictor for usingyour unit as a blower.
• Open the inlet cover by insertingthe
tip of a sorewddver intothe inletcover
latcharea, and twistingthe screwdriver
while pullingthe inletcover open.
Bottom view
of unit
• Turn the inlet restrictorcountercrock-
wise and remove itfrom the unit.
Do not close the inlet door. You will
next attach the vacuum tubes.
ATTACHING THE VACUUM TUBES
There are 2 vacuum tubes, an upper
and lower tube, The upper tube iscut
straight on both ends, and attaches to
the blower unit.The second tube is cut
an at angle on the lower end. This
angled end will point toward the
ground during vacuum use.
• Locate the arrows on the upper vac-
uumtube and on the vaouum inlet
area ofthe unit,
UpperVacuumTube
• While holding the inlet cover open,
align the arrows and insert the vacu-
um tube into the opening. Twist the
tube clockwise until it is seated. A
second arrow on the vacuum tube
will align with the arrow on the unit
once the tube twisted completely in
piaea,
Alignarrowsan tube& unit
• Attach the lower vacuum tube to the
upper vacuum tube by aligning the
arrows on the two tubes. Press the
tubes together untilthe lower tube is
fully seated in the upper tube. (About
3 inches)
Upper Tube
Lower Tube
ATTACH THE COLLECTION BAG
Slide the opening of the collection bag
over the blower outlet. Pull the strap
with veloro tightlythrough the buckle
and secure with velcro tabs.
NOTE: Make sure the strap with velcro
is located on the blower outlet as
shown, Also, make sure the zipper on
the bag iscompletely closed,
Strap withV_cro I'i
Cdl_
Bag y Newer Outlet
6