Filter
Top Products
twigs, and bits ol paper. Do not vacu-
um stones, gravel, metal, broken
glass, etc., to avoid severe damage to
the impeller. To avoidthe possibilityof
electrical shock, do notattempt tovac-
uum water or other liquids.
• Never run the unit without the proper
equipment attached. When used asa
vacuum, ak,/ays install vacuumtubes
and collection bag assembly, Make
sure the collection bag assembly is
completely zipped when unit is run-
ning to avoid flying debris, Use only
recommended attachments,
• Avoid situations which could set the
collection bag on fire. Do not vacuum
discarded matches, cigars, cigarettes,
or ash from fireplaces, barbecue pits,
brush piles, etc. To avoid spreading
fire, do not use blower near leaf or
brush fires, fireplaces, barbecue pits,
ashtrays, etc.
• Always use the ¢oUestionbag shoul-
der strap when vacuuming to avoid
lossof control.
• Check air intake openings, elbow
tube, and vacuumtubes frequently, al-
ways with the unit stopped and the
power source disconnected. Keep
vents and tubes free of debris which
can accumu[ste and restrictproperair
flow. Do not use with any opening
blocked, Keep free of dust, lint, hair
and anything that may reduce airflow.
STANDARDS
This productis listed by Underwriters
Laboratories, Inc., in accordance with
UL Standard 1017.
tf situations occur which are notcov-
ered inthis manual, use care and
good judgment. Ifyou need assis-
tance, contact your Sears Service
Center or call 1-800-235-5878. Fail-
ure tofollow all Safety Rules and Pre-
cautions can result in serious injury.
SAVE THESE INSTRUCTIONS
CARTON CONTENTS
Model 358.799380
Blower
Blower Tu be
Nozzle
2 Vacuum Tubes
Co[lection Bag
Examine parts for damage, Do not use
damaged parts.
NOTE: If you need assistance orflnd
parts missing or damaged, call
1-800-235-5878.
ASSEMBLY
,_WARN|NG: If received as-
sembled, repeat all steps to ensure
your unit is properly assembled and all
fasteners are secure.
ASSEMBLY INSTRUCTIONS FOR
USING YOUR UNIT AS A BLOWER
NOTE: Assembly Instructions for using
your unit as a vacuum follow this sec-
t{on.
ATTACHING THE BLOWER TUBE
AND NOZZLE
Ifyou have already assembled your
unit for use as a Vacuum, remove the
vacuum tubes and the collection bag,
• Insertthe blowertube into the blower
outlet.
• Twist the blower tube clockwise until
it is firmly seated inthe blower outlet.
• Twist the nozzle intothe end of the
bidwartubeuntilitis firmly seated.
Make sure the nozzle points upward.
B_ov_r Outlet
BlowarTube
Nozzle
5