Filter
Top Products
HOWTOREMOVEANOBJECT
FROMTHEAIRINTAKE
NOTE:Iftheunitbecomesclogged,or
anobjectisdrawnintotheair intake,
stopthe unitand disconnect the exten-
sion cord. Wait until the impeller has
completely stopped turning, then re-
move the vacuum tubes. Caretuily
reach into the vacuum opening and
clear out the air intake area.
Inspect the impeller for cracks. If
cracked or damaged, do not use the
unit. have parts replaced by your
Sears Service Center. Do not attempt
to replace them yourself,
PARTS AVAILABLE
Blower Tube .........
Vacuum Tube Bet ....
Inlet Restnctor .......
Nozzle ..............
Collection Bag .......
Gutter Kit ............
Safety Glasses .......
Extension Cord .......
534852705
530402490
530402045
530402461
530402583
.. 71-79997
.. 71-85707
.. 71-5702
Prepare unit for storage at the end of
the season or if itwill not be used for
30 days or more.
_bWARNING:
• Secure the unit before storing or
transporting.
• Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
• Store unit well outof the reach of
children.
BLOWER STORAGE
• Disconnect from the power source.
• Clean the entire unit.
• Open inlet cover and clean any dirt,
TROUBLESHOOTING CHART
grass, or debris that has cctlected,
Inspect the blower and alltubes.
Close and make sure the cover is
latched.
• Clean air vents and air inlet of debris,
• Store your unit and extension cord in
a well ventilated area and covered, if
possible, to prevent dust and dirtac-
cumulation, Do not cover with plastic.
Plastic cannot breathe and may
cause condensation and eventual
rust or corrosion.
• Check entire unitfor loose screws,
nuts, and bolts. Replace any darn-
aged, worn, or broken parts.
SYMPTOM CAUSE REMEDY
Unit fails to . Switch inthe OFF position. =Slide switchto ON position.
operate. • Extension Cord Disconnected •Reconnect extension cord.
. Circuit breaker tripped, or fuse •Reset circuit breaker or fuse.
blown
• Mechanical failure .Contact your Sears Service
Center.
Unit . Mechanical failure •Contact your Sears Service
vibrates Center
abnormally.
Impeller will •Debris in air intake area. •Clean unit. Remove any
notturn . Mechanical failure debris.
freely. •Contact your Sears Service
Center
10