Filter
Top Products
CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist:
P" All assembly instructionshave been
completed.
v" The discharge chute rotates freely.
P" No remaining loose parts in carton.
P" Check the fasteners. Make sure all
fasteners are tight.
_" Check the air pressure of the tires.
Correct air pressure is from 14 to 17
PSI. See the side of the tire for maxi-
mum inflation. Do not exceed maxi-
mum inflation.
I! On electric start models, the unit was
shipped with the starter cord plugged
into the engine. Before operating, un-
plug the starter cord from the engine.
While learning how to use your snow
thrower, pay extra attention to the fol-
lowing important items:
_' Engine oil is at proper level. Use a
high quality detergent oil classified
=For Service SG, SH, SJ, SL, or
higher".
_" Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline
with a minimum of 85 octane.
/I Become familiar with all controls-
their location and function. Operate
controls before starting engine.
lO