Filter
Top Products
TO INSTALL THE TH ROTTLE
CONTROL ASSEMBLY
0 Place a No 10 x 1-1/2 inch hex head screw down
through the hole in the upper handle right side and
attach the throttle control to the underside of the handle
(see Fig 5)
0 Attach the throttle cable to the right lower handle by
threading a tie strap through the hole in the lower
handle and around the throttle cable on the outside of
the handle
0 Thread the pointed end of the strap through the other
(square) end of the strap and pull tight around the
throttle cable and lower handle.
NOTE: One side of the tie strap is rough, while the other
side is smooth The rough side must be on the inside of the
Ioopformedwhen the ends of thetie strap are put together
0 Try to loosen the tie strap, it it will loosen, it is put
together with the smooth side to the inside of the loop
Remove the tie strap and reverse the direction
• Out off excess strap
HAND GRIP ASSEMBLY
0 Install the hand grips onto the upper handles (see Fig
5). It may be necessary to lubricate the handles with
soap and water to aid assembly
,f CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
MINI TfLLER/CULT/VATOR, WE WISH TO ASSURE THAT
YOU RECEIVE THEBEST PERFORMANCE AND SATISFAC_
TfON FROM THISQUALITY PRODUCT
PLEASE REVIEW THE FOLLOWING CHECKLIST_
,/' All assembly instructionshave been completed
4" No remainingiooseparis incarton,
4" All fasteners have been properly installed and tightened
WHILE LEARNING HOW TO USE YOURMINI TtLLER/CULT/-
VATOR, PAY EXTRA ATTENTION TO THE FOLLOWING
IMPORTANT ITEMS:
,J',/ Fueltank is filled withcorrect gasoline and oil mixture
v',f Become familiar with all controls-their location and
function Operate controls before starting engine
HAND GRIPS
NO. 10 X 1=1/2 INCH
HEX HEAD SCREW
FORMED
WASHER
11/32 INCH
FLATWASHER
TEE
KNOB
HEX
NUT
LEFT
LOWER
THROTTLE
CONTROL
UPPER
HANDLE
CURVED HEAD
CARRtAGE BOLT
RIGHT LOWEF
HANDLE
TIE STRAP
FIG. 5