Filter
Top Products
OPERATION
HOW TO USE THE CURB-HOPPING FEATURE
Because the front wheel and the right rear
wheel are adjustable, the Edger can be used
on uneven surfaces, such as the curb shown
in Figure 12. Set the wheel positions as fol-
iows.
1. Stop the engine.
2. Disconnect the spark plug wire from the
spark plug.
3. Loosen the front wheel knob.
4. Slide the front wheel to the best posi-
tion to clear the curb and balance the
unit.
wheel until the front wheel is level with
the left rear wheel and the unit is setting
on the curb as shown in Figure 12.
7. Loosen the rear wheel knob.
8. Lower the right rear wheel until the
Edger is level and the left rear wheel is
on the curb.
9. Securely tighten the rear wheel knob.
10. Connect the spark plug wire to the spark
plug.
5. Securely tighten the front wheel knob.
6. Use the curb height adjust lever to
lower the front wheel. Lower the front
1_ WARNING: Keep away from the
rotating blade. The blade can
cause injury.
Support Rod
Rear Wheel Knob
Blade Guard
Front
Wheel Knob
Front Wheel
Adjust Lever
Rear Wheel
Figure 12
F-001102M 13