Craftsman 486.24839 Lawn Mower Accessory User Manual


 
A'I-rACHING SNOW THROWER TO TRACTOR
NOTE: An additional person's help may be required to
mount the snow thrower to the front of the tractor.
Place the tractor and snow thrower on a flat, level
surface so that the tractor can be rolled forward to
attach the snow blower.
Remove the Attachment Pin from the snow thrower.
Extend the belt out behind the snow thrower,
making sure the belt is still looped over the top of
the large drive pulley and underneath the two idler
pulleys. The "V" side of the belt must be seated in
the grooves of all three pulleys.
Roll the tractor up behind the snow thrower, center-
ing it between the snow thrower's mounting plates.
Raise the rear of the snow thrower by lifting up on
the lift handle until the notches in the mounting
plates align with the shoulder bolts in the tractor's
side plates. Guide the bolts into the notches.
To ease the assembly of the auger drive belt, delay
the installation of the attachment pin shown in
figure 29 until you have assembled the belt as
instructed for figures 30 and 31.
A'n'ACHMENT PIN
1/8" HAIRPIN
COTTER
- SHOULDER
BOLT
\
MOUNTING PLATE
SIDE
PLATE
FIGURE 29 RIGHT SIDE VIEW
INSTALLING THE AUGER BELT
The auger belt comes preassembled to the pulleys
on the snow thrower housing. Make sure the belt
passes over the top of the auger pulley and then
twists 1/4 turn to pass underneath each side idler
pulley. The "V" side of the belt must mate with the
grooves of the pulleys. See figure 30.
TWIST
1/4 TURN
IDLER
PULLEY
AUGER PULLEY
TWIST
1/4 TURN
IDLER
PULLEY
f-
FIGURE 30
Push the lift handle down to increase slack in the
belt (attachment pin must first be removed).
Remove the 1/8" hairpin cotter that secures the end
of the idler arm spring to the right side of the clutch
idler assembly. Swing the idler arm to the left side.
See figure 31.
Place the auger belt around the rear pulley and
between the two pulleys on the idler arm. The "V"
side of the belt must be seated in the grooves of
the "V" pulleys. See figure 31.
Hold this drawing above you while viewing the
Clutch/Idler Assembly from underneath the
tractor. Right and left in the drawing will be the
reverse of the viewer's right and left.
1/8" HAIRPIN
COFFER
(Removedfrom i
end ofspring)
110"_,v
REAR
IDLER
ARM
LEFT SIDE
OF
TRACTOR
FIGURE 31 VIEWED FROM UNDERNEATH
15