Filter
Top Products
If you need assistance, contact your Failure to follow all Safety Rules and
Sears Service Center or call Precautions can result in serious injury.
1-800-235-5878.
SAVE THESE INSTRUCTIONS
CARTON CONTENTS
Model 358.799341
• Blower
• Blower Tube
• Nozzle
Examine parts for damage. Do not use
damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, call
1-800-235-5878.
£= ____.__
4_ILWARNING: If received as-
sembled, ensure your unit is properly
assembled and all fasteners are secure.
ATTACHING THE BLOWER TUBE
AND NOZZLE
1. Insert the blower tube into the blow-
er outlet.
2. Twist the blower tube clockwise until it
isfirmly seated in the blower outlet.
3. Twist the nozzle into the end of the
blower tube until it is firmly seated.
Make sure the nozzle end points
upward as shown in the following
illustration.
Blower outlet
Blower Tube Nozzle
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as
shown on nameplate of the unit to
power your blower.
• To reduce the risk of electrical shock,
this equipment has a polarized plug
(one blade is wider than the other) and
will require the use of a polarized
extension cord. The appliance plug
will fit into a polarized extension cord
only one way. If the plug does not fit
fully into the extension cord, reverse
the plug. If the plug still does not fit,
obtain a correct polarized extension
cord. A polarized extension cord will
require the use of a polarized wall
outlet. This plug will fit into the
polarized wall outlet only one way. If
plug does not fit fully into the wall
outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to
install the proper wall outlet. Do not
change the equipment plug, extension
cord receptacle, or extension cord
plug in any way.
The extension cord used to reach the
power source must be:
• Specifically marked as suitable for out-
door use. The cord must be marked
with the suffix "W-A" (in Canada "W").
• Heavy enough to carry current from
the power source the full length of ex-
tension cord to the unit. Otherwise,
loss of power and overheating can oc-
cur causing damage to unit. Refer to
table for minimum wire gauge recom-
mendations. The cord must be
marked with the proper wire gauge.
(Appropriate extension cords are avail-
able at Sears.) Do not use multiple
cords.
• In good condition. Cord insulation
must be intact with no cracks or
deterioration. Plug connectors must be
undamaged. DO NOT use multiple
cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS 25 FT. 50 FT. 100 FT.
_ 16 14
A.W.G * A.W.G *
•AmericanWire Gauge
Secure the extension cord to the unit by
tying the cord onto the cord retainer. In-
sert the cord receptacle in to the re-
cessed plug.
5
Cord
Receptacle
Recessed
Plug
on Unit