Filter
Top Products
Whenoperatingunit,standasshown
andcheckforthefollowing:
• Weareyeprotection,hearingprotec-
tionandheavyclothing.
• Holdtriggerhandlewithrighthand
andassisthandlewithlefthand.
• Holdunitsothatengineisbelow
waistlevel.
• Cutonlyfromyourlefttoyourrightto
ensuredebrisisthrownawayfrom
you.Withoutbendingover,keepline
nearandparalleltothegroundand
notcrowdedintomaterialbeingcut.
Donotruntheengineatahigherspeed
thannecessary.Thecuttinglinewillcut
efficientlywhentheengineisrunatless
thanfullthrottle.Atlowerspeeds,there
islessenginenoiseandvibration.
Alwaysreleasethethrottletriggerand
allowtheenginetoreturntoidle
speedwhennotcutting.
HOWTOSTOPYOURUNIT
• Releasethethrottletrigger.
• Pushandreleasetheengine ON/
STOP switch.
CUTTING METHODS
,I_WARNING: Use minimum
speed and do not crowd the line when
cutting around hard objects (rock,
gravel, fence posts, etc.), which can
damage the trimmer head, become
entangled in the line, or be thrown
causing a serious hazard.
• The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip of line does the Line crowded into
worl_
Right Wrong
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences.
• For trimming or scalping, use less
than full throttle to increase line life
and decrease head wear, especially:
• During light duty cutting.
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
TRIMMING - Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact with vegetation. Do not force
trimmer line into work area.
Trimming
3 inches
(8 cm) abov,
ground
SCALPING - The scalping technique
removes unwanted vegetation down to
the ground. Hold the bottom of the trim-
mer head about 3 inches (8 cm) above
the ground and at an angle. Allow the
tip of the line to strike the ground
around trees, posts, monuments, etc.
This technique increases line wear.
Scalping
MOWING - Your trimmer is ideal for
mowing in places conventional lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
14