Craftsman 316.794830 Blower User Manual


 
Add fuel in a clean, well-ventilated outdoor area where there are
no sparks or flames. Slowly remove the fuel cap only after
stopping engine. Do not smoke while fueling or mixing fuel. Wipe
up any spilled fuel from the unit immediately. Always wipe unit
dry before using.
Move the unit at least 30 feet (9.1 m) from the fueling source and site
before starting the engine. Do not smoke. Keep sparks and open
flames away from the area while adding fuel or operating the unit.
WHILE OPERATING
Never start or run the unit inside a closed room or building.
Breathing exhaust fumes can kill. Operate this unit only in a well-
ventilated outdoor area.
Wear safety glasses or goggles that are marked as meeting ANSI
Z87.1-1989 standards and are marked as such. Wear ear/hearing
protection when operating this unit.
Never run the unit without the the proper equipment attached.
To reduce the risk of hearing loss associated with sound level(s),
always wear ear/hearing protection when operating this unit.
Wear heavy long pants, boots, gloves, and a long sleeve shirt. Do
not wear loose clothing, jewelry, short pants, sandals or go
barefoot. Secure hair above shoulder level.
Use the unit only in daylight or good artificial light.
Keep outside surfaces free from oil and fuel.
Avoid accidental starting. Be in the starting position whenever
pulling the starter rope. The operator and unit must be in a stable
position while starting. Refer to Starting/Stopping Instructions.
Do not set unit on any surface except a clean, hard area while
engine is running. Debris such as gravel, sand, dust, grass, etc.
could be picked up by the air intake and thrown out by the
discharge opening, damaging unit, property, or causing serious
injury to bystanders or operator.
Use the right tool. Only use this tool for its intended purpose.
Do not force unit. It will do the job better and with less likelihood of
injury at a rate for which it was designed.
Do not overreach or use from unstable surfaces such as ladders,
trees, steep slopes, rooftops, etc. Always keep proper footing and
balance.
Always hold the unit with a firm grip when operating.
Keep hands, face, and feet away from all moving parts. Do not
touch or try to stop the impeller when it is rotating. Do not operate
without guards in place.
Do not put any object into openings. Do not use with any opening
blocked; keep free of dirt, debris, and anything that may reduce
the air flow.
Do not touch the engine or muffler. These parts get extremely hot
from operation, even after the unit is turned off.
Do not operate the engine faster than the speed needed to do the
job. Do not run the engine at high speed when not in use.
Always stop the engine when operation is delayed or when walking
from one location to another.
Stop the engine for maintenance, repair, to install or remove the
blower tubes. The unit must be stopped and the impeller no longer
turning to avoid contact with the rotating blades.
If you strike or come into contact with a foreign object, stop the
engine immediately and check for damage. Do not operate before
repairing damage. Do not operate the unit with loose or damaged
parts.
Use only genuine factory replacement parts and accessories for
this unit. These are available from your authorized service dealer.
Use of any unauthorized parts or accessories could lead to serious
injury to the user or damage to the unit, and void your warranty.
To reduce fire hazard, replace faulty muffler and spark arrestor.
Keep the engine and muffler free from grass, leaves, excessive
grease or carbon build up.
Never point the blower or blowing debris in the direction of people,
animals, or in the direction of windows. Always direct the blowing
debris away from people, animals, and windows. Use extra caution
when blowing debris near solid objects such as trees, automobiles,
walls, etc.
OTHER SAFETY WARNINGS
Never store the unit, with fuel in the tank, inside a building where
fumes may reach an open flame (pilot lights, etc.) or sparks
(switches, electrical motors, etc.).
Allow the engine to cool before storing or transporting. Be sure to
secure the unit while transporting.
Store the unit in a dry place, either locked up or up high to prevent
unauthorized use or damage. Keep out of the reach of children.
Never douse or squirt the unit with water or any other liquid. Keep
handles dry, clean, and free from debris. Clean after each use,
see Cleaning and Storage instructions.
Keep these instructions. Refer to them often and use them to
instruct other users. If you loan this unit to others, also loan these
instructions to them.
SPECIAL NOTE: Exposure to vibrations through prolonged use of
gasoline powered hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of people prone to
circulation disorders or abnormal swelling. Prolonged use in cold
weather has been linked to blood vessel damage in otherwise healthy
people. If symptoms occur such as numbness, pain, loss of strength,
change in skin color or texture, or loss of feeling in the fingers, hands
or joints, discontinue use of this tool and seek medical attention. An
anti-vibration system does not guarantee avoidance of these
problems. Users who operate power tools on a regular basis must
closely monitor their physical condition and the condition of this tool.
SAVE THESE INSTRUCTIONS