Rechecktheadjustment.Tightenthejamnut
againstthecablewhencorrectadjustmentis
reached.
Adjusting Traction Drive Control
• To check the adjustment of the traction drive
controland shift lever, move the weighttransfer
lever to thetransportposition (shownin on ) and
the shift lever all the way forward to sixth (6)
position.
With the traction drive controlreleased, pullthe
triggersup tothe handle and then push the snow
thrower forward to check that the tracksturn.
• Squeeze tractiondrive controlagainstthe handle
and pullthe starter.The tracksshouldturn.
• Now release the traction drive control and pull
the starter again. The unit should not move.
Before proceeding with adjustment, check to
make sure that the spark plug is
disconnected.
• If the traction drive control needs adjustment,
loosen the jam nut on the traction drive cable
and thread the cable one turn. Recheck
adjustment and repeat as necessary.
• Tighten the jam nut to secure the cable when
correct adjustment is reached.
NOTE: Cables are out of adjustment if augers
continue to tum when auger clutch is released and/or
machine continues to run when drive clutch is
released. For more details, refer to the Service and
Adjustment section.
Adjusting Skid Shoe
The space between the shave plate and the ground
can be changed by adjusting the skid shoe.
• Return weight transfer lever to normal position
before adjusting skid shoes.
• For close snow removal, adjust skid shoes
higher to minimize gap between the shave plate
and the ground.
• For snow removal from uneven ground like
gravel, adjust skid shoes downward to create
sufficient clearance between the bottom edge of
shave plate and the ground. See Figure 16.
• Adjust the skid shoes by loosening the four hex
nuts and carriage bolts and moving skid shoes to
desired position. Make certain the entire bottom
surface of skid shoe is against the ground to
avoid uneven wear on the skid shoes. See
Figure 16.
• Retighten nuts and bolts securely.
Skid
•Hex Nut
Carriage Bot
Figure 16
11