hardwareingroupHofthehardwarepack(on
page5).Pullonthecableandrotateitaroundthe
bottomofthetrigger,withtheinnercableinthe
slot,untilthecableendcanbepushedintothe
triggerhousingandsnappedtight.SeeFigure12.
Trigger
Assembly
Inner Cable
Trigger
Housing
Barrel Slot
Fitting
this end
Figure 12
Note: When the cable is installed correctly, it should
not be possible topull cable out of the trigger housing.
Place the right turn trigger in position
underneath the right handle. Secure with screw
and weld nut from group H of the hardware
pack. See Figure 13. You will need a phillips
screwdriver for tightening the screw. Repeat on
left side.
Turn
S_ot rrigger
Cable
Figure 13
Secure the right turntriggercable to the right
lowerhandle, usingcable tie provided inthe
hardware pack. Make sureto route the cable tie
over the drivecable. See Figure 14.
Trigger Cable
Figure 14
10
Secure the left turn trigger cable to the lower
handle using the other cable tie. Make sure to
route the cable tie below the auger drive cable
so that when the trigger cable is secured by the
cable tie, the auger drive cable is left outsidethe
cable tie. Trim excess ends from each cable tie.
NOTE: The right side cable tie must be used to keep
cable from coming in contact with the moving shift
arm from the transmission.
Lamp Wiring
• Wrap the wire from the lamp down the right
handle. See Figure 15. Plug wire into the
alternator lead wire under the fuel tank (see inset).
_ Trlgger.C+able
aandle
_irm://_ _ :_t_/_ nator
Figure 15
IMPORTANT: Assemble your snow thrower,then
check the adjustments as instructed and make any
final adjustments necessary before operatingthe unit.
Failureto foltowthe instructionsmay cause damage
tothe snow thrower.
Final Adjustments
Adjusting Auger Control
To check the adjustment of the auger control,
push forward the left hand clutch grip until the
rubber bumper is compressed. There should be
slack in the clutch cable.
Release the clutch grip. The cable should be
straight. Make certain you can depress the
auger control grip against the left handle
completely.
If adjustment is necessary, loosen the hex jam
nut and thread the cable in (for less slack) or out
(for more slack).