Filter
Top Products
12 DR
®
WDS 5.4, 5 -TON ELECTRIC WOOD SPLITTER
5. Wrap the Power Cord around the Power Cord
Keeper (Figure 5).
6. Insert a Wheel Axle all the way into the hole at the
rear of the frame (Figure 6) and install a 6mm Bolt
(Figure 7). Tighten the Bolt with the 10mm
Wrench (Figure 7).
7. Repeat step 5 for the other rear Wheel on the
opposite side of the machine.
8. Remove the Operating Handle Retaining Screw
and Washer from the end of the Handle Shaft.
9. Insert the Operating Handle Shaft into the
recessed hole on top of the cylindrical shaft
protruding from the right rear side of the machine.
Thread the Retaining Bolt with Washer up through
the hole in the bottom of the cylindrical shaft and
into the Operating Handle shaft (Figure 8).
10. While holding the Operating Handle Grip tight
with the flat surface of the Operating Handle Grip
facing forward, tighten the Retaining Bolt using the
6mm Hex Wrench (Figure 8).
BEFORE ATTEMPTING TO OPERATE YOUR NEW DR 5 -TON ELECTRIC WOOD SPLITTER, READ THE SECTION
TITLED “BEFORE STARTING THE ELECTRIC MOTOR” ON PAGE 13 IN THE SAFETY
&
OPERATING
INSTRUCTIONS
MANUAL.
If you have questions, please call one of our Technical Support Representatives
TOLL-FREE:
1-800-DR-OWNER (376-9637).
Figure 5
Figure 6
Figure 8 Figure 7
Flat surface facing forward
Power Cord
Keeper