Filter
Top Products
CALL TOLL FREE 1-800-DR-OWNER 7
Hydraulic Safety
ESCAPING PRESSURIZED FLUID FROM HYDRAULIC SYSTEM LEAKS CAN HAVE ENOUGH FORCE TO
PENETRATE SKIN AND CAUSE SERIOUS INJURY OR DEATH. HYDRAULIC FLUID CAN REMAIN
PRESSURIZED WHILE THE MOTOR IS OFF DUE TO THE RETURN SPRING FORCE ON THE RAM. ALWAYS
FOLLOW THESE PRECAUTIONS:
• ALWAYS RELEASE RESIDUAL ENERGY FROM PRESSURIZED HYDRAULIC FLUID AND ALLOW THE FLUID
TO COOL BEFORE DOING ANY MAINTENANCE OR REPAIR WORK ON THE WOOD SPLITTER.
• PLEASE FOLLOW THESE STEPS TO DEPRESSURIZE THE SYSTEM AND RELEASE RESIDUAL HYDRAULIC
ENERGY BEFORE STARTING ANY REPAIRS.
- UNPLUG THE WOOD SPLITTER FROM THE POWER SOURCE.
- MOVE THE OPERATING HANDLE DOWN AND UP FROM ONE LIMIT OF TRAVEL TO THE OTHER AT
LEAST FOUR TIMES. HOLD THE HANDLE FOR THREE SECONDS AT EACH LIMIT OF TRAVEL. THE
RAM SHOULD NOT MOVE DURING THE 4TH CYCLE AND SHOULD REMAIN FULLY RETRACTED.
- CALL 1-800-DR-OWNER (376-9637), OR A QUALIFIED HYDRAULIC MECHANIC, FOR ASSISTANCE TO
REPLACE WORN COMPONENTS.
• NEVER USE YOUR HAND OR ANY PART OF YOUR BODY TO CHECK FOR HYDRAULIC SYSTEM LEAKS
WHILE THE SYSTEM IS PRESSURIZED.
• NEVER REMOVE THE FILL/DIPSTICK CAP FROM THE HYDRAULIC FLUID PORT WHILE THE MOTOR IS
RUNNING OR WHILE THE TANK IS STILL WARM AFTER THE MOTOR IS OFF. HOT PRESSURIZED FLUID
CAN CAUSE SERIOUS INJURY, SO WAIT FOR THE HYDRAULIC TANK TO COOL BEFORE REMOVING CAP.
• THE WOOD SPLITTER MUST BE ON A LEVEL SURFACE.
• PERIODICALLY CHECK FOR HYDRAULIC FLUID LEAKS BY PLACING A SHEET OF CARDBOARD UNDER
THE WOOD SPLITTER WHILE THE SYSTEM IS RUNNING.
• GET PROFESSIONAL MEDICAL HELP AT ONCE IF HYDRAULIC OIL PENETRATES ANYONE'S SKIN.
• NEVER ADJUST THE HYDRAULIC SYSTEM.
Tip: Reference page 23 for Troubleshooting Tips.