Filter
Top Products
DR
SCOUT
FIELD and BRUSH MOWER Safety & Operating Instructions 26
4. Remove the clutch cam retaining nut from the clutch cam pivot bolt and lift the cam
off the pivot bolt. (Figure 24)
5. Remove the clutch spring retaining nut from beneath the clutch cam and remove the
clutch spring from the cam.
6. Install the new spring by reversing the above procedure.
7. Replace the belt guard. (See Figure 11 on page 19)
Removing the Wheels
Tool Needed:
(2) 7/16" wrenches or sockets
1. Block the machine so the wheel to be removed is off the ground.
2. While holding the shear bolt head, remove the shear bolt nut, remove the shear bolt
and slide the wheel off. (Figure 25)
3. Do not over tighten the shear bolt nut when reinstalling the wheels.
Figure 25
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
Remove Nut
Shear Bolt