Filter
Top Products
21 DR
SCOUT
FIELD and BRUSH MOWER Safety & Operating Instructions
Removing and Replacing the Blade
Tools Needed:
15/16" wrench or socket
Air wrench if available
Wear gloves
1 x 4 x 6 to brace the blade
1. Block the blade with a piece of
wood between the blade and the
skid on the side of the deck.
(Figure 16)
2. Remove the blade bolt (right-
hand, regular thread) and washer.
3. Remove the blade.
4. Mount the new blade, washer and bolt.
Note: Be sure the blade is seated completely over the small ridge in the spindle hub
before tightening the lock nut.
Figure 16
WARNING! Before performing any maintenance procedure, stop the
engine and disconnect the spark plug wire.
WARNING! Use caution when pushing or pulling the wrench next to
the blade. Wear gloves, if the wrench slips off the nut, you may be seriously
injured.