Filter
Top Products
DR
SCOUT
FIELD and BRUSH MOWER Safety & Operating Instructions 8
Unpacking the Mower
Tools & Supplies Needed:
Screwdriver
Knife
Gloves
Eye protection
Metal shears
1. Stand to one side and cut the banding.
2. Remove the top of the carton. Separate the stapled vertical cardboard ends from
the pallet to access the pallet straps. Be careful of the staples.
3. Pry off the fasteners and cut any ties holding the machine to the pallet.
4. Roll the mower off the pallet. Do not discard your pallet and packaging material
until you are fully satisfied with your machine.
5. Remove blade protector from blade. (See caution note above).
Check the Tire Pressure
There should be 10 psi in each tire.
WARNING! Always wear eye protection when cutting the banding. The
banding may have a lot of tension on it and may snap, striking you when cut.
A
lways stand to one side when cutting the band.
Caution: Wear gloves and be very careful when handling the deck. The
blade is very sharp, and may spin as you maneuver the deck.