Country Home Products DR 4 -TON Log Splitter User Manual


 
22 DR
4 -Ton WOOD SPLITTER Safety & Operating Instructions
SYMPTOM POSSIBLE CAUSE
Log fails to split.
Check the possible causes for the previous ram
operation symptom on page 21.
Incorrect positioning of the log. Re-position the log flat
on the splitting beam with the ends squarely against
the ram face and splitting wedge.
Log exceeds permitted dimensions or the wood is too
hard for the capacity of the machine. The maximum
log length is 20" with a maximum diameter of 10" for
the DR 4 -Ton WOOD SPLITTER.
The wedge has burrs or nicks and needs to be
sharpened. See page 18.
There may be a hydraulic fluid leak. Locate the leak
using a piece of cardboard under the machine and call
1(800) DR-OWNER (376-9637), or a qualified
hydraulic mechanic for assistance, to replace worn
components.
Hydraulic pressure is too low. Call 1(800) DR-OWNER
(376-9637), or a qualified hydraulic mechanic for
assistance to replace worn components.
Ram advances
with a jerky
motion or with
strong
vibrations.
Check the possible causes for the ram operation
symptom on page 21.
Check the hydraulic fluid level. See page 18.
Bleed any accumulated air from the hydraulic system.
See page 8 and page 18, Step 5. If the problem
persists, call 1(800) DR-OWNER (376-9637) for
assistance.
Hydraulic fluid
leaking from the
ram or other
external parts.
Check that the bleed screw has been tightened before
moving the machine. Use care: Do not over tighten
and strip the bleed screw threads.
The hydraulic fluid seals may be worn. Call 1(800)
DR-OWNER (376-9637), or a qualified hydraulic
mechanic for assistance to replace worn components.
Note:
Country Home Products, Inc. has provided parts lists and schematic diagrams as reference
tools only. CHP makes no representation or warranty of any kind to the buyer that he/she is
qualified to make any repairs to the product or that he/she is qualified to replace any parts o
f
the product. In fact, CHP expressly states that all repairs and parts replacement should be
undertaken by certified and licensed technicians and not by the buyer. The buyer assumes al
l
risk and liability arising out of his/her repairs to the original product or replacement parts
thereto, or arising out of his/her installation of replacement parts thereto.