Filter
Top Products
DR
4 -Ton WOOD SPLITTER Safety & Operating Instructions 19
Electrical Connections
End of Season & Storage
Wipe down the wood splitter to remove any moisture, wood chips and dirt that
may have accumulated on the log guide rails, hydraulic control and motor fan
housing.
Apply a thin coating of oil or #2 Lithium Grease to the wedge cutting edge to
prevent rust.
Store the DR 4 -Ton WOOD SPLITTER in a dry area to prevent moisture from
damaging the electrical components of the machine.
Make sure that the Air Bleed Screw is tightened (See Figure 4 on page 11).
WARNING! When performing any maintenance, you must first unplug the
w
ood splitter from the power source and make sure the hydraulic
system is depressurized and the fluid has cooled. Read the
"Safety Considerations" chapter of this manual before
performing any repairs or maintenance.
WARNING! The DR 4-Ton WOOD SPLITTER MUST be grounded.
Important! Use care, do not over tighten and strip the Air Bleed Screw threads.