Filter
Top Products
9.0 Main Panel Operation
There are two modes of operation;
1. Autolearn mode; System automatically searches for all SCAEL Interfaces connected to
the loop.
No text is available in this mode. This mode can be used for initial checking.
(Note: SCAEL Interfaces must be programmed)
2. Commissioned Mode; The Panel is re-commissioned using a PC to download Address,
Group, type of luminaire, Number of Cells, Duration, Descriptive address text for each
fitting and Test times.
9.1 Initial Power Up (Autolearn Mode)
Switch Mains power on and connect Batteries
After an initial test the display will show;
At this point the system is checking to see how many SCAEL Interfaces are connected.
After a short period the display will show for example;
The system is now ready for limited use without descriptive text for the location.
9.2 Commissioning
In order for the display to show user chosen specific text, the Panel must be Commissioned by
a Cooper Lighting and Security Service Engineer using a PC to download the required
descriptive text;
To Re-Commission, enter the Engineer Passcode.
The display will show;
Press (, the display shows;
Press &, the display shows;
Press &.
The display will light all LEDs in turn and then the display will show;
Press &, the display will show;
See Downloading section (Page 25)
19
EASICHECK™
WAITING FOR THE MASTER TO TRANSMIT THE
NUMBER OF FITTINGS INSTALLED
SYSTEM HEALTHY ! No of FITTINGS= 198
DATE : dd/mm/yy TIME : 10:07:58
1: TIME 2: DATE 3:TEST SCHEDULE
4: RE-COMMISSION 5: QUIT
ARE YOU SURE YOU WANT TO RE-COMMISSION ?
PRESS 1 FOR YES PRESS 5 FOR NO
ATTENTION !!! THIS WILL ERASE ALL DATA !
PRESS 1 FOR CONTINUE PRESS 5 FOR ABORT
TRANSMIT TEXT WITH PC PRESS 1
NO TEXT AVAILABLE PRESS 2
PLUG PC INTERFACE UNIT INTO THE EASICHECK
WITH PC READY TO TRANSMIT