Filter
Top Products
Page 12SKU 96405 For technical questions, please call 1-800-444-3353.
Always turn the Power Switch of the Pole Saw to the “OFF” position, unplug it
from the outlet, and allow it to cool down completely before adding oil.
To ll the Oil Tank (42), remove the Oil Cap (41) and add up to 5 Ounces of high-
quality chain saw oil. Replace Oil Cap when full.
Attaching the Chain.
Drive Sprocket
(31)
Chain Tension
Screw (40)
Pole Saw shown with Plastic Cover (34) removed.
Guide Bar (36)
Chain (35)
Remove the Plastic Cover (34) and align the Chain (35) along the groove in the
Guide Bar (36) and over the Drive Sprocket (31). The directional arrows on the
Chain must correspond with the directional arrows on the Guide Bar or the Pole
Saw will not function.
Adjust the Chain Tension Screw (40) until the Chain is secure. The Chain should
not be adjusted too tightly, since it does have to be able to move. When properly
adjusted, the Chain should be able to be pulled, using light force, about 1/4”
away from the Guide Bar and snap back without sagging.
Replace the Plastic Cover before use.
Assembling the Telescopic Pole.
Connect Aluminum Tube 1 (45) and Aluminum Tube 2 (52) with Connector 1
(46). Secure Plastic Coupling 1A (48) and Plastic Coupling 2A (51) with Screws
(43), and Nuts (8, 47). Fasten with Locking Knob (50)
Connect Aluminum Tube 2 (52) and Aluminum Tube 3 (57) with Connector 2
(53). Secure Plastic Coupling 1B (55) and Plastic Coupling 2B (56) with Screws
(43), and Nuts (8, 47). Fasten with Locking Knob (50).
Functions
The Telescoping Pole Saw is designed to trim branches on trees.
2.
3.
1.
2.
3.
1.
2.