Filter
Top Products
Page 7SKU 90282
Operation
Note: The vehicle battery must be fully charged and the engine running before using
the Electric Winch.
1. Disengage the clutch by pulling out, then turning the Clutch Knob (17) to lock in the
OUT position.
2. Grab the Hook (27) with the Manual Handle (25) and pull the cable to the desired
length, then attach the Hook to item being pulled. Make sure the Hook spring-loaded
latch is set.
Caution: Always leave at least four turns of cable on the drum. Review Winch Safety
Warnings and Precautions on page 3 before continuing.
3. Re-engage the clutch by turning the Clutch Knob until it locks in the IN position.
Caution: Avoid damaging the vehicle transmission. Do not have the transmission in
Park or in any gear. Set the Emergency Brake and place wheel chocks, then put in neu-
tral.
4. While standing aside of the tow path, press (and hold) the IN pushbutton on the
Remote Control to pull the load. If the load will not move, release pull switch and
check for obstacles blocking the load, or check to see if load is too heavy for Winch
capacity.
Press (and hold) the OUT pushbutton to release the load. Wait until the motor stops
before reversing directions.
5. When the pulling is complete, secure the load so it cannot move in either direction.
Caution: The Utility Winch is designed for intermittent use only, and should not be
used in a constant duty application. The duration of the pulling job should be kept as
short as possible. If the Winch motor becomes very hot to the touch, stop the Winch
and let it cool down for several minutes. Never pull for more than one minute at or near
the rated load. Do not maintain power to the Winch if the motor stalls as it can damage
the motor or gears.
Maintenance
Lubrication
1. All moving parts within the Winch have been lubricated using high temperature lithium
grease at the factory. No internal lubrication is required.
2. Lubricate cable periodically using a light penetrating oil.
Cable Assembly Replacement (to be performed only by a qualified service tech.)
1. Move Clutch Handle to the OUT position.
2. Extend Wire Rope (27) cable to its full length. Note how the existing cable is
connected to the inside of the drum.
3. Remove old Cable Assembly and attach new one.
Caution: Do not replace with inferior cable. Always use the approved replacement part