Filter
Top Products
Page 5SKU 90282
21. Apply blocks to vehicle when parked on an incline.
22. Re-spool cable properly in a smooth pattern as shown in the photo below.
23. Not to be used for aircraft purposes.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that the following parts are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
Installation
Warning: Injury or death could occur if this Electric Winch comes apart from its mount-
ing location when it is under load. For that reason, it should only be installed by a
qualified technician.
1. Align the Winch on the vehicle mounting frame (not supplied). Make drill marks
through the mounting holes.
It should be aligned and secured to a solid, flat part of the vehicle (capable of
supporting the Winch and load capacity) where the full rated load will be evenly
distributed. Also remember that the Winch is designed for horizontal pull, not vertical.
2. Remove the Winch and drill two 5/16 inch holes through the vehicle mounting frame.
3. Secure the Winch to the vehicle mounting frame using Mounting Nuts, Bolts, and Lock
Washers (not supplied). Securely tighten.
Clutch Knob (17)
Remote Control (26)
Mounting Holes
REV 04/04