Filter
Top Products
Page 7For technical questions, please call 1-800-444-3353.SKU 66910
REV 10h
Phase 1
Note: Leave Bolts (28, 32) only nger tight
until the end of Phase 2.
Place cupped side of Curved Washers
(27) against Legs (24, 26) during
assembly.
Place Axles (25) into Legs (24, 26). 1a.
Note the position of Left and Right
Legs in diagram.
Secure front Axle in place using Curved 1b.
1c.
through Split Washer (83), Washer (31),
Washer (27), in that order. Thread bolt
into end of rear Axle (25). Snap a Wheel
Cover (33) into place over each hub.
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INSTRUCTIONS section at
the beginning of this manual
including all text under
subheadings therein before set up
or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch off and
unplug the power cord before
assembling or making any
adjustments.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
A
A
B
C
C
B
33
2425262728
32 31 30 29
83